![]() Repeatedly press the PRESET button until the desired preset number appears in the display and the unit tunes to the station.Repeat these steps for up to 10 presets, as desired. Press the PRESET button again to confirm the setting and the station will be saved into memory. Press the TUNE UP or TUNE DOWN button to select a preset number (01-10).“P” and “#” (the preset number) will blink on the display. Then press and hold the PRESET button to create a preset for the current station. To set a radio preset, FIrst, follow the steps in the previous section to tune a station.Notes: When the unit turns ON, it is always on radio mode as default if no Line in audio cable is connected. Manual tuning mode: Repeatedly press TUNE to manually move through the frequency bands.Scanning mode: Press and hold to scan through the frequency bands scanning starts from the currently-tuned station and stops when a station is received.Preset tuning mode: Press the PRESET BUTTON repeatedly to select the desired preset (P01 to P10).There are multiple methods to select the station of your choice. Press the POWER BUTTON to switch the unit ON. DST (Daylight Savings Time) playing the radio.(Follow battery manufacturer’s directions). ![]() Do not try to recharge a battery not intended to be recharged – it can overheat and rupture.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones. Do not mix different types of batteries together (e.g.A reversed battery may cause damage to the device. Be sure to follow the correct polarity when installing the batteries as indicated. ![]() Use only the size and type of batteries specified.Replace only with the same or equivalent type. Warning – Danger of explosion if batteries are incorrectly replaced.When replacing the battery, do not disconnect the AC power adapter otherwise the current time, alarm, and station presets will be erased.įollow these precautions when using batteries in this device: The battery indicator will appear and flash in the display when there are no batteries or when the batteries are low and need to be replaced. Note: The batteries are used to back up the clock and alarm times when the AC adaptor is disconnected or there is a power failure. Replace the battery door back on the compartment.Alkaline batteries are recommended for the longest playing time. Insert two (2) ‘AAA’ batteries as shown.open the battery door by pushing in on the tabs, then remove the door.Two (2) ‘AAA’ size batteries are used to back up the clock, alarm time, and preset memories if the AC/DC adapter is disconnected or there is a power failure. inside the boxĬR220 Digital FM clock radio, AC power adapter, user guide, a set of cable spool and cable clip. Dispose of batteries properly according to environmental regulations.Use only the same or equivalent type batteries as there is a danger of explosion if the incorrect batteries are used or they are installed incorrectly.Do not place this unit in closed bookcases, racks, or other spaces without proper ventilation.Keep open flames, such as lighted candles, away from this unit.Do not impede the ventilation of this unit by covering the ventilation openings with items such as newspapers, table-cloths, curtains, etc.Batteries should not be exposed to excessive heat such as direct sunshine, Are, etc.Please note the information printed underneath the unit.Ensure that the AC/DC adaptor is easily accessible. ![]()
0 Comments
Leave a Reply. |